 |
- Programs DC-Foundation: ZTVK form
for graphics and results available for all programs.
Program DC-Pit: Earth pressure acc. to DIN 4085:2007 incl. spatial earth pr.,
design of reinforced concrete also with 1.0-fold normal force if critical,
wall friction angle phi/2 for diaphragm walls,
design acc. to Indian standard (IS 456 / IS 800) available.
Analysis of sheet pilings as double or single planks, approximate approach acc. to Baumgart-Davidenkov / Brinch Hansen foll. EAU E 115 for the check against piping failure, if no permeability coefficients are available,
new approach for elastic bedding acc. to EB 102
(Recommendations on Excavations 2006).
Program DC-Pile: NEW: settlement of micro piles,
support of Recommendations on Piles (EA-Pfähle) 2006
Program DC-Geotex / DC-Gabion: french version available
Program DC-Nail: complete italian version available.
Program DC-Footing/Pylon: fixed pylon footings acc. to Steckner (Bautechnik 2/1989), improved approach with soil layers, ground water level, slopes and excavation conditions.
Program DC-Gabion: Analysis of gabions, layered blocks and concrete stack stones acc. to the bulletin of FGSV.
Program DCBORE: Layer specification form acc. to EN ISO 22475-1
new DIN 4023:2006 available as well as DIN 4943:2005 for graphics of wells and ground water measuring points with cover sheet and data sheets B1, B2 and B3!
Display of symbols acc. to British Standard BS 5930 available !
Program DC-Footing: Analysis of single, block and sleeve footings,
rectangular, strip and circular footings:
Design incl. punching, shear force and sleeve design,
all foundation engineering and stability checks with optimization,
incl. cantilever footing, centering by bend-proof wall or foundation slab
European standards for
Sieve and sedimentation analysis acc. to DIN and CEN ISO/TS 17892-4
in program DCSIEVE,
Consistency limits acc. to DIN and CEN ISO/TS 17892-12
in program DCCONS,
Permeability test acc. to DIN and CEN ISO/TS 17892-11
in program DCPERM,
Density and Water content acc. to DIN and CEN ISO/TS 17892-1 and –2
in program DCDENS,
Dynamic probing acc. to DIN EN ISO 22 476-2 in program DCPROBE,
Shear strength test acc. to DIN and CEN ISO/TS 17892-10
in program DCSHEAR
- Program
DC-Pit: Support of the new recommendations EAU 2004 and EAB 2006 now available: reduced safety factors, new calculation of additional depth, new calculation of partial fixity, new redistribution figures, incl. separate output of section forces from dead / live / water loads.
DC-Software partner offer: get your free voucher!
You use DC-Software and have an own website ?
Set a link to www.dc-software.com (e.g. on a page “Software use” or “Office equipment”) and you will receive a purchase voucher of 100 Euro which will be charged with your next software purchase. If you set an additional link to our German website www.dc-software.de, you will receive an additional amount of 100 Euro. Send us the link to your page via email or fax. You will then receive your voucher immediately.
|
|
|
